Keypad 1 is designed to control Room 1 and allows selection of sources 1,Ģ, 3, 4, 5, and 6. Two keypads have been included with the program. PleaseĬomment this logic from the program if the Sonnex Tool is used. However, the program currently sets these values after a 'device ready pulse' is received. Minimum volume, maximum volume, startup volume, mono/stereo audio, and loudness settings are recommended to be set Because of the nature of outputīussing in a Sonnex system, each room is already designed to be included in an output bus if desired, and may be set using the Of the SWE-8) are designed to have Fixed Mode active, which must also be set with the Sonnex Tool. Furthermore, Room 22 and Room 23 (outputs 7 and 8 Output 8 of the SWAMP-24x8, which should be set up using the Sonnex Tool. Room 7 is designed to be a bridge between output 7 and The project allows for selection of twenty-three rooms and eight sources. This program implements a Sonnex Audio solution through the use of a SWAMP-24x8, one SWAMPE-8, and a SWE-8. Hook the signal to the touch panel device symbol and set the relevant page feedback join in the touch panel project. Signal that drives the touch panel to go to the source control page.ĥ. Remove the '//' from the beginning of the applicable Find the SWAMP TP Room GUI Interface modules for touch panels that will be able to control the source. Add the corresponding device control pages to touch panels that will be able to control the source.Ĥ. Making sure the source is available in one of the 'List Position' parameters.ģ. Make the source available for selection on touch panel scrolling lists for desired rooms by selecting the appropriate SWAMP Audio Zone modules and

Source numbers correspond directly with theĢ. Adjust the source name and icon on the SWAMP Audio Video Conduit found in the 'System Logic' subsystem.

When adding actual sources to the system, the following steps should be taken:ġ. Actual sources have not been programmed source namesĪnd icons exist purely to demonstrate available features. This program demonstrates the use of the suite of modules necessary for programming a Sonnex system.

Xpanel ipid